Only using part of the paper



This is probably staring me in the face - but how do I print on just part of a sheet without it printing gloss on all of the rest of the paper?


Printing test pieces on large sheets.







It’s a little convoluted but you need to set your top and bottom margins to be everything (vertically) that isn’t printed.


So if the top of my test strip was 5 inches from the top and the bottom of my test strip was 8 inches from the bottom, I would make a new custom papers size with a 5 inch top margin and 8 inch bottom margin.

Or you can use the NWGCO curves.