Gray Margins Around Printed Image

ttruex · October 18, 2020, 6:03pm

Hi all,

Sorry if my question has been repeatedly answered.

I finally got around to converting my p800. After several heavy head cleanings and a good nozzle check I tried a test print using Print-Tool. The resulting print has a grey margin printed around the image. I must have missed a step or done something else wrong but I can’t figure out what is causing it.

Here is a scan of the print showing the margins.

PiezographySupport · October 20, 2020, 8:52pm

Please let me know what inks are in what channels and share a screenshot of your settings (what curve you are printing with) etc.

best,
Walker

ttruex · October 22, 2020, 9:46pm

I’m getting good prints. I’m not sure I know what I ‘fixed’. I suspect it was something in the QTR curve settings but I had mucked around so much that when I started completely over everything looked right so I decided to try again and the print was fine.