Hi Walker
thanks for helping out with this.
- Am using iProfiler 3.2.1
- Am lost at this point. When I start iProfiler, if i1Pro3 is not connected, everything is in Demo mode, and there is not much that one can do. If I start with i1Pro3 connected, the only workflow I see is Application Settings > Default Display Device > there are options, I can pick i1Pro2 or a combined ‘i1Pro3 | i1Pro3 Plus’ and that is it.
If I pick i1Pro2 here, I cannot find any way of changing to i1Pro3.
So, I tried to go to Advanced mode, then looked for some way of following above instruction but no go.
Could you provide more specific details? Sorry to bother you!
Thanks,
P